AMAZE is a
biodegradable cleaner and conditioner that instantly dissolves all kinds of grease,
dirt and marks on your pool’s liner.
A clean liner lasts longer. AMAZE’S
cleaning power and rapid action make it easy to use and very effective.
AMAZE may also be used on garden furniture, vinyl-coated metal parts and
1. Spray the product on a cloth, sponge or soft
2. Gently rub the surface until stains disappear. Add a small
amount of AMAZE if needed.
1. Rinse the surface with water. Wipe up if
It is the responsibility of the user to make sure
that colours and patterns hold on to cleaned surface.
Item ID: (30-21280-11) Brand: IPG
SOLAR BLANKET AND
WINTER POOL COVER CLEANER
cleans all kinds of dirt, deodorizes and protects pool covers during storage. Helps
prevent mildew and makes the cover easier to fold.
and protects pool covers
1. Flush loose leaves and
debris from cover with a garden hose.
2. Apply COVER CLEANER
liberally in its concentrated form and scrub the cover with a brush.
Rinse the cover thoroughly with water.
Item ID: (30-21421-11) Brand: IPG
OR CARTRIDGE FILTERS
FILTER CLEANER is a cleaner scientifically formulated to insure a
better filtration and to prolong filter life.
Removes accumulated dirt in
cartridge or sand filters.
FILTER CLEANER is effective in removing
scale, rust, oils and cosmetic residues.
1. Stop filter and remove cartridge.
2. In a plastic
pail prepare a solution of 1 L of FILTER CLEANER per 20 L of warm water. The
solution will be a peach colour.
3. Place cartridge upright in the solution,
making sure that there is enough solution to cover cartridge.
4. Allow to
soak for about 5 to 6 hours.
5. Remove cartridge and rinse immediately
with fresh water.
6. Replace cartridge and start filtration system.
and increases the effectiveness of the filter’s sand.
1. Make sure the
pool water is at maximum level above the skimmer.
2. Stop the filter and
make sure the skimmer basket is clean and empty.
3. Make sure the
filter is on the “Filter” position. Pour the contents of the bottle into the skimmer.
Start the filter and let it run for 5 seconds then stop. Let stand for 8 hours.
4. After 8 hours change the position of the filter to “Backwash”, start the filter
and let it run for 2 to 5 minutes. Stop the filter, put the filtration system back to the
“Filter” position and restart.